How to change a locksmith?
The lock is a closing mechanism which can only be opened by a key or a corresponding combination. In a fault situation, it happens that a lock can no longer be opened in another way. The last possible solution to unlock it is to pierce it. Of course, drilling will completely destroy the barrel. To perform such an operation, and at the risk of not seeing the whole mechanism as a whole damaged, you have to go with a certain method. Here are the elements necessary for a perfect success of the operation of drilling a barrel in locksmithing.
What is a locksmith barrel?
How to identify the type of lock?
Lock drilling
What is a barrel in locksmith?
In locksmithing, a barrel is a small cylindrical barrel-shaped hollow part which by its use, allows the locking or unlocking of a lock. It comes in many shapes and sizes. There are different profiles for each lock mark, ie rounds of different diameters, or tongue-and-groove barrels, etc.
Identify the type of lock
Identifying the type of lock is the first step to drill the barrel of a lock. You should know that some locks can not be pierced . These include tubular locks and locks with ball bearing in the central piston. To open these types of locks, you will have to fall back on other picking techniques.
The only locks that can be drilled are those with conventional pins. Contact a hardware store near you or a locksmith when you are unable to identify your type of lock. Then send your contact information about your lock, it will identify to do the identification exercise for you. In addition to the type of lock, check to see if your door has a lock or alarm. If so, of course, disable these systems before drilling.
Lock drilling
An electric drill with adjustable speed and bits of different sizes are largely sufficient to pierce the barrel of a lock. For the actual drilling, follow the steps below:
With a hammer and a punch, make a pilot hole above the key channel. This pilot hole will serve as a guide for drilling. It can be very difficult to find the precise place where to register the guide point, because you are not used to it. Obtain a lock drilling template from a hardware store. It has the advantage of making your life easy. visit homepage
Start drilling your barrel from the guide point (3 mm drill bit). Drilling destroys the pins inside the barrel, which in turn allows the lock to be forced. Common lock models have 5 or 6 pins.
Each time you touch a pin, you should feel some resistance that will decrease sharply once the pin has been pierced;
Be careful, do not press too hard when you drill a barrel, your wick may break under pressure. Also, to avoid further damage to your lock, make sure your drill stays straight while drilling.
Increase the size of your wick (6 mm), once all the pins pierced. Then insert a flat screwdriver into the hole, the barrel should be easily removed once you pull the screwdriver. You just have to install a new barrel .
As you will have noticed, drilling a barrel requires skill and mastery. The risks of doing worse than better are relatively huge. The best thing to do will be to contact a competent locksmith near you to replace a lock. Up to you !
Staffing 360 Solutions (Nasdaq: STAF) Reports Third Quarter and Nine-Month 2022 Results




